Foundation design
Footing analysis and design
Tedds supports analysis and design of footings for Eurocode and USA. These calculations quickly check the analysis and design, or analysis only, of a pad or strip foundation in reinforced or plain concrete.
Watch the video at TUA
Pile analysis
To speed up foundation design time, this pile analysis calculation for both Eurocode and USA, does a static analysis of the resistance capacity of single piles, driven or drilled, in multiple geomaterial strata. Steel, concrete, or timber piles can be analyzed for compressive and tensile axial loads and lateral loads. Lateral load analysis is for short rigid piles only.
Watch the video at TUA
RC Pile cap design
This pile cap calculation for both Eurocode and USA, checks the design of pile caps supporting a single column with up to 9 piles. The column may be subject to axial compression or tension, shear loads, and biaxial bending. Possible load cases include permanent, imposed, snow and wind for all load types. Permanent and imposed surcharge loads may be defined. Steel, concrete or timber piles can be defined with compression, tension, and shear capacity. Defined capacities are compared to analysis results.
Watch the video at TUAConcrete raft slab/slab on ground
This concrete calculation quickly assesses the ability of elements of a raft to support various loading arrangements without exceeding the allowable bearing pressure. It also determines the quantities of reinforcement required to support the loads whilst spanning theoretical circular depressions in the sub-soil which are assumed to form beneath the raft.
Steel sheet piling design
This calculation for steel sheet piling design Eurocode and USA checks the stability of either a cantilever or a propped/tied steel sheet pile wall. It determines the required minimum embedment length and then calculates the minimum required plastic section modulus per meter run of wall. The calculation will determine the tie/prop force where appropriate.
Watch the video at TUA
